At Professional Machine and Tool we know that if you dont
start right you wont end right. We have invested in four full time, in house
designers to ensure that your projects get off to the right start. Their combined
experience is approximately 65 years in the die making industry. These men work together as a team reviewing each project to ensure
that we have maximized the material usage, and also maximized the control of the strip so
that the dimensional integrity of the part is ensured.
The first step in this process is a strip layout, which is
sent to you for approval. The next step is plan and section views that are again sent to
you for your approval. From that the detailing is then done.
After design completion the shop foremen review your design
again and each block is routed by operation through the plant to ensure that the delivery
dates that have been promised are attained too.
These designers also work as a support team
throughout the process to assist with changes and to see that all changes are reflected in
the final design.
We are able to handle your files and wire frames, by
e-mail, modem, floppy disk; CD, Zip disk (100-250 MB), and they can be furnished in Dxf,
iges, and dwg formats.
Our designers are also able to do solid modeling with
Solidworks software.
- We do it right the first time.
- We maximize material usage
- We use correct geometry to ensure details can be replaced
with just a phone call.
- We maximize the ability to repair the tool to minimize
maintenance.
- We use state of the art equipment and software.
|